Motorcycle Clearcoat Gone On Engine Sidecovers: A Step-by-Step Guide to Restoration

Motorcycle engine sidecovers are often exposed to harsh weather conditions, which can damage the clearcoat and cause it to peel or fade. This not only detracts from the appearance of your motorcycle, but it can also lead to corrosion and other problems. If the clearcoat on your engine sidecovers has gone, it's important to have it restored to protect them from further damage.

Motorcycle Clearcoat Gone On Engine Sidecovers In 5 Min ! : A How To Guide For Easy Removal Of Baked Clearcoat! (Motorcycle How To Tips Book 1)

5 out of 5

Language	:	English
File size	:	365 KB
Text-to-Speech	:	Enabled
Screen Reader	:	Supported
Enhanced typesetting	:	Enabled
Print length	:	4 pages

FREE

Step 1: Remove the Engine Sidecovers

Before you can restore the clearcoat on your engine sidecovers, you'll need to remove them from the motorcycle. This is usually a straightforward process, but it may vary depending on the make and model of your motorcycle. Consult your owner's manual for specific instructions on how to remove the engine sidecovers.

Step 2: Clean the Engine Sidecovers

Once you have removed the engine sidecovers, you'll need to clean them thoroughly. This will remove any dirt, grease, or other contaminants that could interfere with the adhesion of the new clearcoat. Use a mild detergent and water to clean the engine sidecovers, and rinse them thoroughly with clean water.

Step 3: Sand the Engine Sidecovers

Once the engine sidecovers are clean, you'll need to sand them lightly to create a smooth surface for the new clearcoat to adhere to. Use a fine-grit sandpaper, such as 400-grit or 600-grit, and sand the engine sidecovers in a circular motion. Be careful not to sand too deeply, as this could damage the underlying metal.

Step 4: Apply the Clearcoat

Once the engine sidecovers are sanded, you're ready to apply the new clearcoat. Use a high-quality automotive clearcoat, and follow the manufacturer's instructions for application. Apply the clearcoat in thin, even coats, and allow each coat to dry completely before applying the next.

Step 5: Buff the Clearcoat

Once the clearcoat has dried, you'll need to buff it to remove any imperfections and give it a glossy shine. Use a soft cloth and a polishing compound, and buff the clearcoat in a circular motion. Be careful not to buff too hard, as this could damage the clearcoat.

Step 6: Reinstall the Engine Sidecovers

Once the clearcoat has been buffed, you're ready to reinstall the engine sidecovers on your motorcycle. Follow the instructions in your owner's manual in reverse order to reinstall the engine sidecovers.

Restoring the clearcoat on your motorcycle engine sidecovers is a relatively simple process that can be completed in a few hours. By following these steps, you can protect your engine sidecovers from further damage and keep your motorcycle looking its best.

Motorcycle Clearcoat Gone On Engine Sidecovers In 5 Min ! : A How To Guide For Easy Removal Of Baked Clearcoat! (Motorcycle How To Tips Book 1)

5 out of 5

Language	:	English
File size	:	365 KB
Text-to-Speech	:	Enabled
Screen Reader	:	Supported
Enhanced typesetting	:	Enabled
Print length	:	4 pages

FREE